Mando Blaster

• • • • • • • Assembly Instructions • • • • • • •

Assembly

1. Lay out the parts to get an idea of how they go together. This will keep you from accidentally putting it together wrong.

2. Tools needed: Phillips screw driver and superglue or epoxy.

4. Glue the connecting surfaces as shown.

5. Screw the parts together with a 1/2″ screws

8. Screw the parts together with 2 1/2″ screws.

9. At this point you can paint it then when you are done pop on the orange tip if you are going out in public with the gun.

Painting

The gun is ready to be painted. I will replace the above picture with an example of how I paint it. You can fill the connecting parts with model putty and lightly sand it smooth, but I usually don’t bother. Please note the plastic used in this model is pla which is strong but will melt if you sand it with a power sander. I also tend to skip primer.

I use gunmetal spray paint and finish it with lacquer. If you want to get technical you can brush on detail colors. I recommend Vallejo paint from Amazon if you take that route.